Dinnerware Decals Water Transfer Decals for Ceramic Bowls

Our waterslide ceramic decals are usually used to domestic ceramics and craft bone ceramic, magnesia porcelain, high temp white porcelain, heat-resistant porcelain and medium and low temperature ordinary ceramics.The waterslide transfer decals for ceramic dinnerware bowls are safe and can pass environmental test and washable test.And ceramic decals can meet various firing conditions.

Material:water slide tansfer decal paper
Paper baseweight:175gsm or others
Process Size:390*540mm,500*700mm
Sampling time of ceramic bowls decals:one week
Process:silk screen printing
Decal type:on glaze ceramic decals
Firing temperature:bowls decals for fire temperature 800c
Application:domestic ceramics,such as bowls,ceramic plate,cooking ware,etc
Ceramic bowls decals pattern:flower or custom

The features of waterslide decals for ceramic dinnerware:

1.Safety:meet lead and cadmium test requirements;
2.Our dinner ware decals can pass dishwasher test;
3.Scratch resistant and strong adhesion;
4.Knockout speed of paper is quick;

How to use waterslide transfer decals for ceramic bowls:

Stage 1: Wipe the ceramic bowls that you want to stick clean (no duration time requirement, clean is ok).
Stage 2: Cut one pattern from the 50cm*70cm water transfer decal paper (no duration time requirement, cutting well is ok).
Stage 3: Soak and wet the pattern completely in water (wet completely is ok), warm water(20C-30C) needs to be used in winter.
Stage 4: Place the pattern onto the correct position of the ceramic bowls, wait for 1-2 minutes before moving the base paper, If not movable, wet completely again. If movable, move the base paper away carefully in one direction.
Stage 5: After moving the base paper, the pattern has been transfer printed on the ceramic bowls, then squeeze out completely any excess water and air bubble with rubber or other tools (no duration time requirement, squeezing out completely is ok).
Stage 6: Dry the water around the pattern with dry towel (no duration time requirement, dry is ok).
Stage 7: Place the ceramic bowls has been printed pattern into a oven, then curing(baking) time in small oven is 2 hours ( from heating to cooling), the curing temperature is 780C-800C.
Noted; The high temperature ceramic decals need positive stick, that means the side of the pattern must face up or face to the operator(users).